Installation of Dymetrol^® Into Booth Seating

Straight Booth Seats

This method simplifies installation of Dymetrol^® by eliminating stretching tools and expediting the manufacturing process. It involves stapling a pre-cut panel of Dymetrol^® to the outer edges of two frames and then using the frames themselves, wedged against each other to produce the required stretch. Staple inner edges, cut apart and pull the Dymetrol^® snug over the sides and staple in place.

NOTE: The width of the Dymetrol^® (monofilament length) is determined as follows:

A. Measure distance "D"

B. Multiply "D" x 1.9 = Width of Dymetrol^® (monofilament length minus 5% - two frames per installation)

C. Be certain black monofilament is installed so it places seat joints in compression and is on the underside of the deck. Monofilaments are to be oriented front to back in most booth seating applications.

NOTE: Prior to installation, break all sharp edges where the Dymetrol^® will come into contact with the frame. Use recommended staple and staple pattern. Refer to Bulletin No. 1 (H-04610)

H-16773