Sofa Deck - Manring Method

For Simple, quick installation of Dymetrol^® into wedges.

Step 1
Modify side rails and stretch rails as shown in Fig. 1 to accomodate the frontand rear rails.

Step 2
Attach Dymetrol^® to front and rear rails-Fig. 2.

Size of Dymetrol^® is determined as follows:

A. Measure distance "D" (Monofilament Length).

B. Multiply "D" x 0.95 = width of Dymetrol^®. (Allows for 5% stretch)

C. Measure and cut width (W) to allow 1-2" overlap on sides of wedge.

NOTE: Prior to installation, break all sharp edges where the Dymetrol^® will come into contact with the frame. Use recommended staple and staple pattern. Refer to Bulletin No. 1 (H-04610)

Step 3
Place rear rail into notches in the stretch rails and fasten in place (screw or frame staples) Fig. 3.

Step 4
Stand front rail vertically in notch - Fig. 3 and 4.

Step 5
Use hand tool to rotate front rail through 90^o and fasten into place - Fig. 5-7.

Step 6
Pull Dymetrol^® snug (by hand) over sides and staple into place - Fig. 8.

H-04612